Quick Start Guide

Everything you need to get started, use your device, and start selling your new services — all in one place.

Start your Treatment

Step 1

Screw quick connector

Step 2

Tighten with the wrench

Step 3

Insert hose

Step 4

Open Tank

Step 5

Turn on the device

Step 6

Start Treatment

Finish your Treatment

Step 1

Turn off the device

Step 2

Close the Tank

Step 3

Purge the gas from the device

Step 4

Disconnect hose

Understanding Your Subzero Device

The Subzero cryotherapy device uses targeted cold therapy for benefits like pain relief and faster recovery. This non-invasive system supports wellness and rehabilitation. Learn its components here for safe use.

Controls and Operation

- ( I ) Turns the device on and additional click begins treatment
- ( O ) Stops treatment | Selects treatment time | Turns off device
- Begin by selecting ( I ) to turn on the device
- Select ( O ) to program the treatment time: 30s/60s/90s/Fog/Massage(3sec)/continuous
- Select the ( I ) button to begin the treatment
- Select the ( O ) button to stop the treatment at any time
- Select and hold the ( O ) button to turn the device off
- Simultaneous click of the ( I ) and ( O ) buttons hile the device is on will switch from Celsius to Fahrenheit

How to charge the device:

Plug it in for 90 minutes

Facts to Remember

- CO2 tank must be ordered with a SIPHON TUBE
- Always hold diffuser 5-6 inches from skin
- Complete a sweeping diagnosis of skin before treatment (skin temp will display)
- Blue light indicates skin reaches 8°C/46°F (Therapeutic Temp)
- Red light indicates skin temp reaches 0°C/32°F (Too cold, you need to move to another area or move further from the skin)
- Flashing red light indicates you are too close from the skin if you don’t adjust within 3s, the device will stop
- After 1 minute of non-use, device will enter sleep mode

Item added to your cart